a. Press down on both of the top-cover latch buttons, and slide the top cover off the controller canister.
b. Release the tab that secures the battery to the controller canister.
56000-00
3
1
2
1
Top-cover latch buttons
2
Battery
3
Locking tab
c. Remove the battery by sliding it towards the rear of the controller canister.
d. Repeat these steps for controller B.
2. Follow these steps to install the batteries into the new controller canisters:
a. Unpack the new controller canister, and set it on a flat, static-free surface with the top cover up.
Save the packing materials in case you need to return the old controller canisters.
b. Press down on both of the top-cover latch buttons, and slide the top cover off the controller canister.
c. Insert the battery at a slight downward angle into the controller canister.
d. Slide the battery into the canister, making sure it stays below the rivets on the wall of the canister.
e. Keeping the locking handle at a 45-degree angle, align the connectors at the bottom of the battery with the connectors on
the canister.
f. Push the battery down until you hear it click, and move the locking handle up to secure the battery to the controller
canister.
Attention:
To make sure that the battery is seated correctly, you might need to slide it out and insert it again. You
know it is secure when you hear it click into place and when the locking handle does not move out of its upright
position when you wiggle it.
g. Repeat these steps for the second controller canister.
3. Go to
Replacing the controller canisters
on page 17.
14
Changing the Host Protocol in the E5600 or EF560 by Replacing Hardware Components
