Quantum StorNext QD7000, Replacing Manual

Page: 8 / 8

4 NetApp® E-Series Storage Systems: Replacing a Power Canister in the DE6600 Drive Tray
11. Slide the replacement power canister all the way into the drive tray. Rotate the power canister latches towards the center
to lock the power canister into place.
12. Make sure that the Power switch on the replacement power canister is turned off, and then plug in the power cord.
13. Turn on the Power switch on the replacement power canister.
14. Check the green Power Input AC Power LED and the amber Power Service Action Required LED on the new power
canister.
15. Based on the LED status, perform one of the following actions:
—
The Power Input AC Power LED is on and the Power Service Action Required LED is off
– Go to step
17.
—
The Power Input AC Power LED is off or the Power Service Action Required LED is on
– Check that the
power canister is installed correctly. Reinstall the power canister. Go to step
16.
16. Did this action correct the problem?
—
Yes
– Go to step
17.
—
No
– If the problem has not been resolved, contact your Technical Support representative.
17. Check the status of all of the trays in the storage array.
18. Does any component have a Needs Attention status?
—
Yes
– Click the
Recovery Guru
toolbar button in the Array Management Window, and complete the recovery
procedure. If the problem has not been resolved, contact your Technical Support representative.
—
No
– Go to step
19.
19. Remove the antistatic protection.
20. Gather support data about your updated storage array by using one of these methods:
—
Use the storage management software to collect and save a support bundle of your storage array. From the Array
Management Window, select
Advanced >> Troubleshooting >> Support Data >> Collect
. Then name and
specify a location on your system where you want to store the support bundle.
—
Use the CLI to run the
save storageArray supportData
command to gather comprehensive support data
about the storage array. For more information about this command, refer to
Command Line Interface and Script
Commands
. Running this command can temporarily impact performance on your storage array.