Quantum Scalar LTFS Appliance: Rail Replacement
6-68096-01 Rev A
December 2013
Reinstalling the Chassis in the Rack
5
Figure 3 Installing the Tool-less
Rails (Round Holes)
Rail teeth
Release
button
Rail pegs
Front side of rack rails
Second tooth
engaged
Back of
rack
Release
button
Front of rack
Note:
When using round hole rails, the Scalar LTFS Appliance may protrude
from the rack by approximately 1/8 inch (0.3175 cm).
5
Place the Scalar LTFS Appliance on a level surface and align the four J-slots
on the chassis rails with the corresponding pins on the system. Slide the
chassis rails towards the back of the system until each one locks into place
(see
Figure
4
on page
6)
Reinstalling the Chassis in the Rack
To reinstall the Scalar LTFS Appliance chassis back into the rack, complete the
following steps:
WARNING:
Ensure that the system is properly supported until the chassis rails
are locked into the slide rails on both sides.
