Quantum Scalar LTFS Appliance: Rail Replacement
6-68096-01 Rev A
December 2013
Replacing the Rails in the Rack
3
Figure 1 Pulling the Scalar LTFS
Appliance From the Rack
Chassis
Rack rails
Chassis rail
7
To remove the rails, pull the latch release button on the end piece midpoint
and unseat each rail.
Replacing the Rails in the Rack
To replace the rails in the rack, complete the following steps:
Note:
When replacing the rails refer to
Figure
2
on page
4 for square holes
and
Figure
3
on page
5 for round holes.
1
Position the left and right rail end pieces labeled
FRONT
facing inward and
orient each end piece to seat in the holes on the front side of the vertical
rack flanges.
2
Align each end piece in the bottom and top holes of the desired U spaces.
3
Engage the back end of the rail until it fully sets on the vertical rack flange
and the latch locks into place.
4
Repeat
Step
1
through
Step
3
to position and seat the front end piece on
the vertical rack flange.
