Quantum Scalar i40 Replacement Manual Download

Page: 4 / 4

Quantum Scalar i40 and Scalar i80:Power Supply Replacement
6-66559-02 Rev C
February 2014

Replacing a Power Supply with a Filler Plate

status of the power supply’s LED: the power supply LED should turn green

immediately to indicate the library is turned on.

Replacing a Power Supply with a Filler Plate

These instructions explain how to replace a power supply with a filler plate.

Note: On the Scalar i80

, if you are using only one power supply, you should

install the power supply in the upper slot, and cover the lower slot with

Hold the filler plate with the thumbscrews at the top.

Insert the bottom edge of the filler plate into the slot, engaging the bottom

edge of the filler plate into the bottom of the slot.

Pivot the filler plate up to fit securely in the hole.

Tighten the thumbscrews.

Summary of Contents for Scalar i40

Page 1: ...ountries All other trademarks are the property of their respective owners Quantum specifications are subject to change Scalar i40 and Scalar i80 Power Supply Replacement The Scalar i40 contains one po...

Page 2: ...e library has only one power supply you must power off the library proceed to Step 1 If the library has a redundant power supply you can replace the power supply without powering off the library proce...

Page 3: ...raight into the slot You may need to press firmly on the power supply sheet metal at the very end to plug in the power supply to the connector on the library You will feel it snap into place The power...

Page 4: ...ions explain how to replace a power supply with a filler plate Note On the Scalar i80 if you are using only one power supply you should install the power supply in the upper slot and cover the lower s...