ATL P-Series Library User’s Guide Addendum - Prism FC230 Router
6331121-03, Ver. 3, Rel. 2
August 2002
14
Fibre Channel Services Command List
FcPortFailure
(Immediate)
Controls the behavior of FC ports
while the bridge is in AddressB
(failover) mode.
fcportfailover fp [recover | force [loopdown
| portdown | isperr]]
The recover option should be selected for
actual failover operation.
The force option forces a failure for testing
and demonstration purposes by simulating
loss of FC synchronization (loopdown), ISP
chip failure detected by fabric (portdown), or
internal ISP chip error (isperr).
FcPortList
(Immediate)
List the available Fibre Channel
ports and their current status.
fcportlist
FcSCSIBusyStatus
Specify the SCSI status value
returned when the FC230 is unable
to accept a SCSI command due to a
temporary lack of internal
resources.
QFULL
set fcscsibusystatus [busy | qfull]
get fcscsibusystatus
FcTargets (Immediate)
Displays information about every
FC device visible to a bridge
operating in initiator mode.
fctargets <fp>
FcWWName
Reports the World Wide Name
(WWN) of the referenced Fibre
Channel interface.
get fcwwname [portnumber]
FibreBridgeModel
Report the specific FC230 model
information.
get fibrebridgemodel
FibreBridgeName
Specify the 8-character name
assigned to the FC bridge.
“........”
set fibrebridgename [name]
get fibrebridgename
FibreBridgeTargetL
UN
Specify the soft target LUN used by
the FC bridge when addressed by
the host. This LUN is taken from
NVRAM.
14 (all FC
ports)
set fibrebridgetargetlun [0 - 31]
FirmwareRestart
(Immediate)
Reboot the FC bridge firmware.
firmwarerestart
Help (Immediate)
Displays a list of available
commands. When the optional
command name is present, detailed
command-specific information is
displayed.
help [command name]
IdentifyFibreBridg
e
Causes the “Fault” LED on the
FC230 board to blink continuously
until disabled.
disabled
set identifyfibrebridge [enabled | disabled]
get identifyfibrebridge
Command
Description
Default
Syntax