Quantum LTO-3, Quick Start Manual

Page: 10 / 18

10 Installing the Tabletop LTO-3 (Model B) Half-Height Tape Drive
Product Name Quick Start Guide
Restarting the Internal
Tape Drive System
After connecting the internal drive interface and DC power cables:
1 Restart the workstation or server system.
2 Verify that the internal LTO-3 (Model B) Half-Height Tape Drive comes on and
completes the Power On Self Test (POST) functions.
3 As required, proceed to either:
• Installing the LTO Driver Software on page 15
• Registering the LTO-3 (Model B) Half-Height Tape Drive on page 15
Installing the Tabletop LTO-3 (Model B) Half-Height Tape Drive
To install the tabletop LTO-3 (Model B) Half-Height Tape Drive, complete the following
procedures in the order presented:
1 Depending on the interface configuration of the drive:
2 Connecting the Tabletop Drive Interface and AC Power Cables
3 Restarting the Tabletop Tape Drive System on page 14
4 Installing the LTO Driver Software on page 15, if required
5 Registering the LTO-3 (Model B) Half-Height Tape Drive on page 15
Configuring the
Tabletop Parallel SCSI
Tape Drive
The factory-set default configuration of the tabletop parallel SCSI LTO-3 (Model B) Half-
Height Tape Drive is:
• SCSI ID: 6
• Terminator power: enabled
IF the drive interface is . . . THEN . . .
parallel Small Computer
System Interface (SCSI),
proceed to Configuring the Tabletop Parallel SCSI
Tape Drive in the following subsection to configure
the SCSI ID.
serial-attached SCSI (SAS), there is no need to configure the SCSI ID, as SAS is
a point-to-point architecture. Skip to Connecting
the Tabletop Drive Interface and AC Power Cables
on page 11.
IF the default parallel SCSI ID
configuration is . . . THEN you can . . .
compatible with your system
SCSI bus,
skip the following subsection and proceed to
Configuring the Internal Parallel SCSI Terminator
Power on page 5.