22
Installing the 1U Rackmount Enclosure in a Rack
LTO-3, LTO-4, LTO-5, LTO-6, LTO-7 and LTO-8
Completing the
Installation
To complete the rackmount enclosure installation:
1
Extend the stabilizing feet if provided on your rack.
2
Extend the left and right rack rails from the front of the rack.
3
Align the rear of the component rails on the tape enclosure with the front ends of
the rack rails, then slide the unit fully into the rack (see
Figure 27
).
Figure 27 Sliding the 1U Rack
Enclosure into the Rack
Caution:
Be sure to keep the enclosure parallel to the floor when sliding the
component rails into the rack rails. Tilting the enclosure up or down
could damage the rails.
Note:
To remove the enclosure from the rack, disconnect the cables from the back
of the unit. Press the latches on each side and pull the enclosure from the
rack (see
Figure 27
).
4
Tighten the front panel thumbscrews.
5
If used, retract the stabilizing feet of the rack.
6
Plug the AC power cord into the power cord connector, then into a grounded outlet
(see
Figure 28
).
FR
ONT
Latches
