![background image](http://html1.mh-extra.com/html/quantum/lto-3/lto-3_installation-manual_4066159017.webp)
Installing the 1U Rackmount Enclosure in a Rack
17
LTO-3, LTO-4, LTO-5, LTO-6, LTO-7 and LTO-8
Figure 21 Attaching the Inner
Rack Rails
Note:
To remove the component rail, pull out the spring-loaded tab on the side of the
rail and slide it forward.
Installing the Rack Rails
Installation procedures differ depending on the rack type. The rails are shipped ready for
installation in racks with round or square holes. If the rails are to be installed in racks
with 10-32 threaded holes, the mounting pins must first be removed. Refer to the
following sections for installation instructions for your rack type:
•
Installing in a Rack with Round or Square Holes
•
Installing in a Rack with 10-32 in. Threaded Holes
Installing in a Rack with Round or Square Holes
To install the 1U rack enclosure in a rack with round or square holes:
Note:
The ends of the rack rails are marked FRONT and REAR for proper orientation.
1
Insert the pins in the front mounting plate of the outer rack rails into the previously
marked holes in the front vertical mounting bars of the rack (see
Figure 22
). The rack
rails will lock securely into place.
Inner rack rail
Spring-loaded tab