OCTAGON J-BOX
GASKET
page 2
INSTALLATION and MOUNTING
A.
Disconnect DC Power Input connector from PCB enclosure during first
part of installation. Use code-approved connectors to connect input leads
inside J-box (not included) [See label on wire pair for positive and negative
polarity colors].
B
. Route input harness into the J-Box (not included).
C
. For wet applications install the gasket and/or silicone sealant as
required to seal the remote lamp housing to junction box (not included).
D
. Carefully place the PCB enclosure inside the J-Box (not included) and
connect input connector to the PCB enclosure. See Illustrations on page 3.
E.
Taking care not to pinch wires or connectors dressed inside junction
box, secure remote housing (adapter plate provided, if needed) to junction
box screws. NOTE: to ensure proper engagement of the remote housing
to the J-Box (not included), DO NOT OVER-TIGHTEN THE SCREWS.
Junction box mounting:
-Some details shown below may vary-
1
Part # 912-00076-001
Rev. D, 06/2021
© 2020, Acuity Brands Lighting, Inc.
All Rights Reserved.
IMPORTANT:
Provide ELMRW LP220L with DC power supply from 5V through 20V and SP640L units with a DC power
supply from 5V through 20V un-switched circuit used for emergency lighting.
WARNING:
During installation of remotes, wires from main unit to remote units
must
NOT be connected to each other
or
connected to ground. Failure to do so will lead to failure of the main unit.
NOTE
:
The maximum mounting height with tilt and swivel lamp heads is shown below to meet the minimum illumination
requirements of NFPA 101 (current Life Safety Code).
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
Junction boxes accommodated
(not included)
:
SINGLE W/
4” SQ J-BOX
(Adapter Plate Included)
SINGLE W/
4” ROUND J-BOX
SINGLE W/
4” OCTAGON J-BOX
ROUND J-BOX
GASKET
PLASTER RING
(Not Included)
SQUARE J-BOX
ADAPTER PLATE
GASKET
(
This gasket to be used as a template for making a
drill in the wall).
SILICONE SEALANT
TO BE APPLIED
BETWEEN ADAPTER
PLATE AND WALL TO
PREVENT LEAKAGE
screw
Accessory package content:
1.
Adapter plate
2.
Housing gasket
2
Housing mount-
Pan Head Screw
Housing Gasket
Adapter Plate
Adapter Plate mounting-
Flat Head Screw
ELMRW LP220L SGL
8.7 feet
ELMRW SP640L SGL
24.4 feet
ELMRW LP220L T
11.8 feet
ELMRW SP640L T
31.9 feet
3.
Adapter plate mounting - flat head screw
4.
Housing mount - pan head screw
