Chapter 9: Configuration
Scheduler
Quantum DXi4700 User’s Guide
270
Note:
For more information about configuring the DXi4700 for replication, see
.
To schedule replication throttling:
1. On the
Scheduler
page, add or edit an event in the
Replication Throttle
).
2. Specify the maximum allowed bandwidth by entering a value in the
Bandwidth
box and selecting the
units in the drop-down box (
KB/s
or
MB/s
). The lowest value you can set is 32 KB/s. The highest value
you can set is 125 MB/s for 1 GbE and 500 MB/s for 10 GbE.
Caution:
Do not set the maximum allowed bandwidth to a value that is lower than necessary. If the
maximum allowed bandwidth is set to the lowest value, large replication jobs may fail.
During the replication throttle event, the DXi will limit the amount of data it sends during source
replication so that it does not exceed the specified bandwidth. After the replication throttle event ends,
the DXi will no longer throttle the sending of source replication data (until the next replication throttle
event occurs).
Do
not
configure a throttle schedule if a constant throttle is enabled (see ). The scheduled replication
throttling bandwidth settings take precedence over the constant throttle value. (The currently active
replication throttle rate appears on the
Home
page under
Current Activity
.)
3. (Optional) Specify when and how often the event reoccurs (see
Setting Recurrence for a Scheduled
).
4. Click
Apply
.
About Replication Throttling Statistics
Keep in mind the following information when observing actual network bandwidth usage during a
replication throttle event:
l
During a replication throttle event, only outgoing replication data traffic is throttled, not other outgoing
traffic. Because of this, you may observe network usage to be higher than the specified maximum
bandwidth. Differences in the sampling time period may also cause discrepancies between the
specified maximum bandwidth and observed traffic.
l
If the DXi is configured to use a bonded network interface for replication traffic, load balancing is
determined independently by the bonding mode selected for the interface (see
). Because of
this, you may need to sum the values for all slave devices in the bonded interface to calculate the
overall outgoing traffic rate.
l
The replication throttle bandwidth maximum is specified in KB/s or MB/s, so depending on the statistic
or report you are observing, you may need to convert the bandwidth maximum to Kb/s or Mb/s in order
to correctly compare it to the observed values.
Scheduling E-mail Reports
The DXi4700 can automatically generate a report with system status data or with configuration data and
send it to all configured e-mail recipients.
