Quantum ATL PowerStor L200 Series, User Manual

Page: 93 / 106

77 ATL PowerStor L200 Series Library User’s Guide
Appendix B OCP Error Messages and Error Definitions
Appendix B
OCP Error Messages and Error
Definitions
B
Table 27 lists OCP Error messages, descriptions, and recommended
operator actions.
Table 27 OCP Error
Messages
“OCP Display Description Recommended Operator Action
Drive Stuck in
Flux
This indicates that the drive power
during initialization exceeded the
timeout allowed for that operation. The
drive was still in the “Flux” state when
the timeout occurred. Unload drive and retry the operation. If
the operation fails again, contact an
authorized field service engineer.
Cartridge Fault
Door Unlocked
The initial scan of the magazine slots
and the tape drive indicates that there
are more cartridges in the system than
there are slots to store them. Remove excess cartridges.
Remove Cart from
Elevator
This indicates that the unit detected
either too many cartridges in the
system or a homeless cartridge was
found in the elevator. Remove excess cartridges and restart.
Drv <n> In Flux
or
Drv <n> HwError
or
Door Unlocked!
These error messages appear when the
OCP is used to initiate a system test
routine. Each message indicates a
reason why the test can not be initiated. Correct problem and retry.
LDR ERR: <x>
or
DLC ERR: <x>
The error code was returned by the
loader process. Error code descriptions
are listed in “Library Error Definitions”
on page 79.
DRIVE ERROR!
An error occured communicating with
the tape drive(s).
Cleaning FAILED
The attempted cleaning cycle failed. Check for a valid cleaning cartridge in
the required slot and that the cleaning
cartridge has not expired.