13
Drive Profile Selection
Your Q-Logic 2 Controller may be programmed for up to five drive
profiles that allow the system to be custom-tailored to your
environment. The drive profile may be changed two different ways.
Profiles 1-5 may be selected by pressing the On/Off and Mode Select
Lever in the forward direction. Profile 1 may be selected by simply
pressing the Key 1 select button. The selected profile is displayed on the
Drive Screen.
NOTE: Drive profiles are set by your Quantum Rehab Provider.
Contact your Quantum Rehab Provider to change or add a drive
profile.
To select a profile setting using the On/Off and Mode Select Lever:
1. Push the On/Off and Mode Select Lever up once to power on the
chair and the controller.
2. Push the On/Off and Mode Select Lever up again to select a drive
profile. Continue to cycle through the five available drive profiles.
NOTE: You can only scroll forward through the drive profiles.
Pushing the On/Off and Mode Select Lever down will power off the
controller.
WARNING! Drive/Function Inhibit status is read-only in
your actuator adjustment (seat screen). This function
is disabled in drive mode in order to prevent unintended
loss of function in your power chair. Take caution when
negotiating obstacles, ramps, and inclines. Whenever
possible, utilize an attendant in these conditions.
WARNING! Operating your power chair on inclines and/
or with tilt/recline function will affect your power
chair’s stability.
Actuator Adjustment (Seat Screen)
The Q-Logic 2 Controller can control five power seat actuators using
the mode select lever and the joystick.
To select and adjust an actuator:
1. Push the On/Off and Mode Select Lever up once to power on the
chair and the controller.
2. Push the On/Off and Mode Select Lever up several times until the
seat screen is displayed on the LCD or push the key 2 select button
once to go directly to actuator mode.
Summary of Contents for Q-Logic 2
Page 95: ...95 ...