26
www.quantumrehab.com
Quantum 600E
V . C O M F O R T A D J U S T M E N T S
9. Use wire ties to secure the controller cable to the seat frame.
10. Reinstall the rear shroud and tighten the fasteners.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 17.
2. Loosen the foot platform securement nut one-half turn.
3. Raise or lower the foot platform to the desired height.
4. Reinstall the quick release fasteners into the foot plat-
form bracket and tighten.
5. Tighten the foot platform securement nut.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot plat-
form bracket. See figure 17.
2. Move the foot platform securement in or out to the de-
sired height
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the
power base with two quick release fasteners. See figure 18. Each
quick release fastener consists of a bolt, a lever, and a nut. See figure
16. The lever has a cam on the end that allows it to clamp into place.
The quick release fastener has two states: clamped and unclamped.
When the lever is open, the quick release fastener is unclamped.
When the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Figure 17. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
FOOT PLATFORM
RETAINING PIN
QUICK RELEASE
FASTENERS
Figure 18. Quick Release Fastener Operation
LEVER (OPEN)
BOLT
NUT
CAM
UNCLAMPED
CLAMPED
LEVER (FULLY CLOSED)
SECUREMENT
NUT
