Quantum Design ZillioX 6, Manual

Page: 18 / 59

Manual for ZillioX 6
Chapter 2
13
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in power-off status
can be powered up by a ring signal received from the internal modem. If this function is to
be used, please be sure an internal modem card which supports this function is used. Then
connect this header to the relevant connector on the modem card, set “ Resume by Ring” to
Enabled from the “ POWER MANAGEMENT SETUP” section of the BIOS. Save & exit, then
boot the operating system once to make sure this function takes effect.
Chassis Security (CHSSEC)
The connector can be connected to the chassis security switch on the case. When using
QDI’ s ManageEasy software, the system can detect the status of the chassis. For detailed
information, refer to the ManageEasy manual located in the path \Doc from the QDI
motherboard utility CD.
CD Audio Connector (CDLIN, MITSU)
The CD Audio Connector can be connected to a CD-ROM drive through a CD audio cable.
With the speakers connected to Speaker-out/Line-out jack, audio can be heard from the
CD-ROM drive.
+5V standby
GND
Signal for waking up (active low)
WOM
CHSSEC
GND Indicate signal
MITSU CDLIN (SONY)
CD Right Channel
GND
CD Left Channel
GND
GND
GND
CD Right Channel
CD Left Channel