- 13 -
6.2. Connection to the electrical network
The product should be connected to the 230 V network through a
two core cable. Power supply should be connected to points
N
and
L
of the terminal block located on the rear side of the thermostat.
You do not have to take care of phase correctness during the
connection process (
Figure 3
). It is not necessary to connect a
ground wire because the product is double insulated.
6.3. Mounting the thermostat
To install the thermostat you should separate the front plate from
the black plate. To do so, slide the front plate of the thermostat
up wards and slide the rear part of the product downwards at
the same time (
Figure 4
). Following this, place the rear part of
the product into the 65 mm electric wall mount box then secure
it by screws (
Figure 5
). Finally, slide back the front plate of the
product into the back plate.
Figure 4.
Figure 5.
