QUANTOR MINICHILLY SB, Instruction Manual

Page: 9 / 12

9
6. Cleaning of the cooling unit
Casing: Before cleaning the units disconnect the mains plug! Please do not use water
directly on the unit, clean only with a wet cloth and a little dish liquid. The cleaning of
the units and the beverage coils (optional for this unit, if used) have to take place
according to the instructions of the industrial safety regulations.
Prevent any moisture from getting into the electric part of the unit!
The condenser fins should be cleaned at regular intervals (min. every six months and
more frequently if required) by qualified personnel to remove the accumulated air dust.
7. Troubleshooting
Error Possible cause Error correction

The unit
does not
start

No main connection

No water in the tank

Thermostat is disconnected

Thermostat does not close circuit

Starting device at the compressor is
defect

Interference of the compressor
(interwinding fault)

Establish main connection
(plug the unit)

Fill in water

Switch on the Thermostat

Change the Thermostat

Exchange the starting
device (relay and
condenser)

Change the compressor

Unit is
running,
but does
not cool

The condenser is blocked with dirt

Failure of the condenser fan

Leakage in the refrigeration system

Compressor interference

Clean the condenser

Exchange the fan

Repair the leakage,
evacuate gas, and fill with
the refrigerant gas
(R134a)

Exchange the compressor

Unit does
not switch
off

Thermostat defect

Leakage in the refrigeration system

Cooling demand is to large

Exchange Thermostat

Repair the leakage, and fill with
the refrigerent (R134a)

Control the cooling
demand and if necessary
reduce the cooling load
All these works have to be carried out by skilled and qualified personnel!
Should it not be possible to take care of the failure, please contact the responsible
service.