Configuration of transmitter programming in the receiver
R1 LED
R2 LED
Standard programming
(default option, the receiver is always
configured on pluri-channel)
The relays are activated 1
st
relay by channel 1, 2
nd
relay by
channel 2 (3
rd
relay by channel 1, 4
th
relay by channel 2)
Flashing
Flashing
Special programming
By pressing any transmitter channel, relay 1 on the receiver will
be activated
ON
OFF
By pressing any transmitter channel, relay 2 on the receiver will
be activated
OFF
ON
By pressing any transmitter channel, both relays on the receiver
will be activated at the same time*
ON
ON
* If working in ON/OFF activation mode, relay 1 will act as impulse and relay 2 as ON/OFF. Therefore, on the
first press relay 1 will close and open the contact and relay 2 will only close. On the second, relay 1 will close
and open the contact and relay 2 will open.
N.B.: Each transmitter can be configured independently on the receiver.
TOTAL RESET
In programming mode, the programming button is held down and the
“MR”
reset jumper is bridged for 3
secs. The receiver will issue 10 short acoustic warning signals followed by others at a faster pace to indicate
that the operation has been successful. The receiver is now in programming mode.
After 10 seconds without programming or quickly pressing the programming button, the receiver will exit
programming mode, issuing two acoustic signals of 1 sec.
USE OF THE RECEIVER
These receivers are designed for use as remote controls for garage doors. Their use is not guaranteed for
directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the
following requirements:
·
For units which are permanently connected, an easily accessible circuit-breaker device must be built into
the wiring system.
·
This unit must always be installed in a vertical position and firmly fixed to the structure of the building.
