TECHNICAL CHARACTERISTICS
WAVE500-2
WAVE500-2B
Frequency
868.35MHz
Coding
High security rolling code
Memory
500 codes
Number of relays
2 (expandable to 4)
Supply
230Vac
12/24Vac/dc
Power supply range
±10%
9-23 / 22-35Vdc
8-16 / 16-27Vac
Relay contacts
1A
Standby/Op. consumption
35mA / 50mA
60mA / 350mA
Access control output
(3 readers max without external power supply)
BUS-L
Op. temperature
-
20⁰C to +85⁰C
Watertightness
IP54 (with glands IP65)
Box dimensions
140x220x55mm
INSTALLATION AND CONNECTIONS
Attach the rear part of the housing to the wall using the plugs and screws provided. Pass the cables
through the bottom of the receiver. Connect the power cables to the terminals marked on the circuit
board, as indicated. Connect the relay outputs and access control readers as required. Fix the receiver
cover to the rear part using the screws provided.
OPERATING
The pilot lights are activated every 5 seconds to indicate the correct power supply to the equipment.
Upon receiving a code, the receiver checks whether it is in its memory, activating the corresponding relay.
The relay activation mode is selected in either impulse or on/off using the Imp/Bies jumper (only with relay
2).
PROGRAMMING
MANUAL PROGRAMMING
Press the receiver programming button for 1 second, an acoustic signal will be heard, release the button.
The receiver will enter standard programming (see table). If the receiver programming button is held
pressed down, the receiver will enter special programming, cyclically passing from one configuration to the
next. Once the programming configuration for the transmitter to be registered has been chosen, send the
code to be programmed by pressing the transmitter. Every time a transmitter is programmed, the receiver
will issue an acoustic signal for 0.5 seconds.
After 10 seconds without programming or pressing the first two transmitter buttons, the receiver will exit
programming mode, issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver
memory is full, it will issue 7 acoustic signals of 0.5 sec. and exit programming.
