ENGLISH
27
Initial Configuration
General Mode CLI Command List Screen
Figure 4-2:
On the prompt, input “
6.
enable
” to enable the
Privilege
mode. In this mode, you can configure
the IP address and execute other advanced CLI commands (see “CLI Documentation” for more
information).
On the prompt, input “
7.
configure
”. The prompt changes to “
(Quanta) (Config) #
”.
Set the service port IP addres (in the example below, the service port IP address is set to
8.
192.168.2.1)
Configure
Serviceport protocol none
Serviceport ip 192.168.2.1 255.255.255.0
exit
Set Service Port IP Screen
Figure 4-3:
192.168.2.1 255.255.255.0
Input “
9.
ip default-gateway <gateway>
” (where <gateway> is a value between 0.0.0.0 to
255.255.255.255).
From this point, the IP address, subnet mask, and gateway of the switch has been set. On the
10.
command prompt, input “
exit
” to go back one level. The prompt changes to “
(Quanta) #
”.
Input “
11.
show ip interface
” to display the network configurations of the switch.
Obtain IP Address by DHCP
4.2.2
When using a DHCP server, the switch obtains an IP address, subnet mask, and default gateway from
the DHCP server. Ask your network administrator to identify the IP address assigned to the switch.
Use this IP address to login to the Web Utility to configure the switch.
