錯誤
!
尚未定義樣式。
— Installing Hardware
19
Installing an Expansion Card
CAUTION!
VOLTAGES CAN BE PRESENT WITHIN THE SERVER WHENEVER AN AC
POWER SOURCE IS CONNECTED. THIS VOLTAGE IS PRESENT EVEN WHEN
THE MAIN POWER SWITCH IS IN THE OFF POSITION. ENSURE THAT THE
SYSTEM IS POWERED-DOWN AND ALL POWER SOURCES HAVE BEEN DIS-
CONNECTED FROM THE SERVER PRIOR TO INSTALLING A PCI CARD.
USE ONLY A QSSC-2U SPECIFIC PCI RISER CARDS WHEN INSTALLING A
PCI CARD.FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN
PERSONAL INJURY OR DAMAGE TO EQUIPMENT.
You can install expansion cards on the system's riser board. The riser board plugs into the riser connector on the
system board. A second PCI card can be installed. Because the lower and upper PCI cards are installed in the
same manner, both use the following procedure.
Note:
The PCI riser assembly does not include a riser card or any cabling as standard.
To install a PCI card, a riser card must be installed. Refer to riser card user manual
for installation procedures.
1.
Remove the riser card. See Replacing the Riser Card on page 26.
2.
Remove the PCI dummy cover from the riser assembly.
3.
Orient the PCI card with the riser guide slot and push in the direction of the arrow until the PCI card sits
in the PCI card connector
. Secure the PCI card with the screw as shown
.
4.
Repeat Step 3 for a second PCI card.
5.
Turn the riser assembly over and replace back on the chassis.
See Replacing the Riser Card on page 26.