20
The maximum output current at voltages above 220V is dis-
played here. Note that the input current and the output current
values may not match at low voltage. In this case, the amount of
current at the output will be lower than at the input. The values
will match at higher voltages (over 220V). This is due to the fact
that the regulator requires more current to provide a stable 220V
at the output at low voltage than at high voltage.
• SCREEN NO.10. MINIMUM INPUT VOLTAGE.
The minimum input voltage at which the regulator will operate
and put out are displayed here. Note that in the case of such a
low voltage, the output power of the regulator decreases in per-
centage correlation. For example, if the input of the regulator is
110V, and this is only 50% of 220V, then the power of the regula-
tor will only be 50% of the nominal. If this threshold is exceeded,
the regulator will limit the input current and shut down soon.
• SCREEN NO.11. MAXIMUM INPUT VOLTAGE.
The maximum allowable voltage at the input of the regulator. If
this threshold is exceeded, the regulator will shut down.
• SCREEN NO.12. TURN-ON DELAY.
Shows how many seconds after start (switching on the automat-
ic circuit breaker) the regulator will supply voltage to the output.
• SCREEN NO.13. SELECTION OF OUTPUT VOLTAGE
220V/230V
Allows you to select the point relative to which the output voltage
220V or 230V will be regulated.
To select the output voltage (switching from 220V to 230V or vice
versa), press the middle button below the screen. When the value
flashes, you can change it with the right and left buttons under
the screen. After selecting the desired value, press the middle
button again and the value will stop flashing. Next, if you want to
save the selection, exit this screen with the right button, if you do
not want to save it - exit with the left button.
• SCREEN NO.14. OUTPUT VOLTAGE CORRECTION.
Minimum Voltage
INPUT: 91V
Maximum Voltage
INPUT: 362V
Timer Power ON
second 6s
Set Voltage
Out = 220V
Set Tuning Out
V0.0%
QUANT-9
Automatic voltage regulator, one-phase
