Quanmax ECX-APL0 Series, User Manual

Page: 22 / 65

Chapter 2
22
ECX-APL0 Series User’s Manual
Jumper Settings
To ensure correct system configuration, the following section describes how to set
the jumpers to enable/disable or change functions. For jumper descriptions, please
refer to the table below
.
Table 2 Jumper List
Label Function
JP1 SIM CARD SELECTION
JP2 Backlight Enable Selection
JP3 Panel & Backlight Power Selection
JP4 AT / ATX Power Mode Selection
JP5 M2 KEY B LED Pin Header
JP6 MPCIE Activity LED Pin Header
JP8 RTC Reset Selection
JP9 USB Power Selection
JP10 ME F/W Selection
Table 3 JP1 SIM CARD SELECTION
1
2
Jumper Status
1-2 Open M.2 KEY-B
1-2 Short MPCIE (Default)
DIP 2P 1R MALE Pitch:2.54mm [Pinrex 210-91-02GB01]
Table 4 JP2 Backlight Enable Selection
2 1
6 5
Jumper Setting Status
1
1-3 Backlight Enable Level = +3.3V
3-5 Backlight Enable Level = +5V
2
2-4 Backlight Enable High Active
4-6 Backlight Enable Low Active
SMD 6P 2R MALE TYPE 180D P-2.0mm[PINREX 222-97-03GBB1]
Table 5 JP3 Panel & Backlight Power Selection
2 1
6 5
Jumper Setting Status
1
1-3 Backlight Power = +12V
3-5 Backlight Power = +5V
2
2-4 Panel Power = +3.3V
4-6 Panel Power = +5V
SMD 6P 2R MALE TYPE 180D P-2.0mm[PINREX 222-97-03GBB1]