Material Required:
•
Loctite 242 Threadlocker
I/O Port Assy.
Y-Clear Detectors
Control Panel
Vertical (Y) Axis
Lead Screw
Front Guide Shaft
Cartridge Magazine
Carriage, Handler, Gripper
and Barcode Reader
Tape Drives
Vertical (Y) Axis
Home Sensor Probe
Y-Clear Emitter Assy.
Spring Cup Assy. and Plastic Washer
Handler Power Supply
Executive PCBA
Tape Drive
Power Supply
Power Switch
Cooling Fans
SCSI Cable
Connectors
AC Power Cord
Receptacle
Drive Bay PCBA
Rear Guide Shaft
Figure 7-3 TLS-4000 Side View – Fixed-magazine Models
7.5.1 Carriage Assembly Removal
1.
Turn off the TLS power and remove the power cord.
2.
Remove the Top Panel as described in Section 7.4.1.
3.
Use a 7/64-inch Allen wrench to remove both socket-head Carriage Cable Clamp
mounting screws (Figure 7-4).
4.
Manually raise the Carriage Assembly up sufficiently to expose the ribbon cable
connector on the underside.
5.
Disconnect the Carriage Assembly's double ribbon cable connector by pushing
outwards on both ejectors (located on the ends of the connector). Set the cable to
the right side of the cabinet.
6.
Lower the carriage to the bottom of the TLS.
7.
Use a 1/8-inch Allen Wrench to loosen the upper Leadscrew retaining screw.
501380 Rev. B
Field–Replaceable Units (FRUs)
7-7
