CAUTION
Be careful not to damage the Carousel Position Sensor with the Carousel Gear
Guard when you install the Carousel (Figure 9-7 and Figure 9-8).
1.
Insert the Carousel through the open cabinet door.
2.
Align the lower Carousel Bearing with the TLS Frame, then lower the Carousel
down into place (Figure 9-8). Use caution as to not damage the Carousel Gear or
the gear on the Carousel Motor shaft as you lower the Carousel into position.
Upper Carousel
Pivot Support
Mounting Screws
(3)
Figure 9-9 Top View of Upper Carousel Bearing
3.
Align the upper end of the Carousel Shaft with the Upper Carousel Pivot Sup-
port (Figure 9-8), then lower the Upper Carousel Pivot Support down through
the top of the TLS onto the upper Carousel Pivot (Figure 9-9).
4.
Align the mounting screw holes in the Upper Carousel Pivot Support with the
mounting screw holes in the TLS, then use a number 2 Phillips screwdriver to
install all three 10/32 x 1/2 Upper Carousel Pivot Support mounting screws.
Tighten the screws securely (Figure 9-9).
5.
Reinstall the Side Panels (Section 7.4.4), then reinstall the Top Panel
(Section 7.4.2).
6.
Proceed to Section 9.2.2 of this chapter.
9.2.1.2
Model 4440 to Model 4480 Expansions
This procedure adds one Receiver Assembly and two Receptacle Assemblies to each of
the two empty carousel faces [four Receiver Assemblies and two Receptacle Assem-
blies total].
Figure 9-11 shows the hole patterns for mounting the receivers.
1.
Turn off the TLS power and remove the power cord.
2.
Open the cabinet door.
3.
Reach in through the cabinet door and rotate the Carousel by hand until an
empty Carousel face (one without Receivers) faces you.
4.
Use four 6-32 x 3/8-inch screws to install a new Receiver Assembly onto the
lower half of the empty Carousel face.
9-8 TLS
Expansions
501380 Rev. B
