3
Step 5: Make sure that the 2 mounting screws are completely engaged into the metal bracket
at the back of the fireplace. See Fig. E
Fig. E
OPErAtiON
After reading complete instructions, confirm all controls on fireplace are in the OFF position.
Plug the fireplace into a 15 AMP/120 volt outlet.
OPErAtiON BY tHE cONtrOl PANEl
The controls are located at the left side behind the front glass.
lefT sIde
O/I:
Press this button for main power. The indicator light will be on. See below for other
control switches.
: STaNdby SwITch:
Press this switch once to turn on the fireplace. Press again
to turn off all functions and enter the standby mode.
: FLaME:
Press this button once for flame effect. The unit will beep and the
indicator light will be On. The bulbs for flame effect will turn On. To adjust the
flame intensity, hold down the button – the flame optics will go higher or lower.
Once you have found the desired setting, release the button. Pressing the button
again will stop the light function.
750w:
Press this button while the 0/I and standby buttons are in the On position for
low heat. The indicator light will turn on. Press this button again to stop the low
heat function.
1500w:
Press this button while the 0/I and standby buttons are in the On position for
high heat. The indicator light will turn on. Press this button again to stop the
high heat function.
NOTE:
When the O/I switch is turned OFF, all other heater functions will stop even
though the switches may be in the On position.
OPErAtiON BY tHE rEMOtE cONtrOl
Plug in your electric fireplace and turn the “0/I”
switch to “I” position. The unit will beep once
and your remote is ready to operate your electric
fireplace heater.
: STaNdby SwITch:
Press this button
once, the unit becomes energized and
you can select the following functions as
desired. Press this button again, the unit
will turn off and enter the standby mode.
: FLaME:
Press this button once for flame
effect. The unit will be beep and the
indicator light will be On. The bulbs for
flame effect will turn On. To adjust the
flame intensity, hold down the button – the
flame optics will go higher or lower. Once
you have found the desired setting, release
the button. Pressing the button again will
stop the light function.
750w:
Press this button for low heat.
The unit will beep, the indicator light will
be on. The fireplace will give low heat
level. Press this button again to stop the
low heat function.
1500w:
Press this button for high heat.
The unit will beep, the indicator light will
be on. The fireplace will give high heat
level. Press this button again to stop the
high heat function.
rEMOtE cONtrOl BAttErY rEPlAcEMENt
Replace with 2 AAA batteries.
WARNINg: dO NOT MIx Old ANd NeW BATTeRIes. dO NOT MIx
AlKAlINe, sTANdARd (cARBON-ZINc), OR RechARgeABle
(NIcKel cAdMIuM) BATTeRIes.