Quality Craft W913T-33BK, Instruction Manual

Page: 7 / 10

7
OPERATION BY THE
REMOTE CONTROL
Plug in your electric fireplace and it will
beep once, this means you have power and
your remote is ready to operate your electric
fireplace.
: Standby switch. Press this button once
the unit become energized and you can
select the following functions as desired.
Press this button again. The unit will be OFF
and enter standby mode.
: Press this button once for flame effect.
The unit will be beep and the indicator light
will be ON. The bulbs for flame effect & log-
set will be ON. To adjust the flame intensity,
hold down the button - the flame optics will
go higher or lower. Once you have found
the desired setting, release the button.
Pressing the button again will stop the light
function.
750W:
Press this button for low heat level.
The unit will beep, the pilot light and indica-
tor light will be on. The fireplace heater will
give low heat level. Pressing once again will
stop the low heat level function.
1500W: Press this button for high heat level.
The unit will beep, the pilot light and indica-
tor light will be on. The fireplace heater will
give high heat level. Pressing once again
will stop the high heat level function.
REMOTE CONTROL BATTERY
REPLACEMENT
Replace with 2 AAA batteries.
WARNING: Do not mix old and new batter-
ies. Do not mix alkaline, standard (Carbon-
Zinc), or rechargeable (Nickel Cadmium)
batteries.
MAINTENANCE
Disconnect power and unplug the power
cord before attempting any maintenance or
A S S E M B LY I N S T R U C T I O N S