5
Fig. M
Once the fireplace heater has been properly installed to the mantel,
plug the fireplace into a 15AMP/120 Volt outlet. If the cord does
not reach you may use an extension cord rated for a minimum of
1875 WATTS.
Note:
Every time the electric heater is plugged in, it will beep once.
This means the heater has connected to the power outlet. The
electric fireplace Heater is ready to operate.
Note:
Ensure the circuit breakers for the power supply are turned
on. The electrical fireplace heater can be operated by the control
panel.
OPERATION
After reading complete instructions, confirm all controls on
fireplace are in the OFF position. Plug the fireplace into a
15AMP/120Volt outlet. If the cord does not reach, you may use
an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electri-
cal outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
O/I:
Press this button for main power function. The unit will beep
and the indicator light will be on. Pressing again will stop the main
power function. Once the heater is switched off, the indicator light
will flash and the unit will keep working with air flow for 5 more
seconds.
FLAME/LOG:
Press this button once for flame effect. The unit
will be beep and the indicator light will be ON. The bulbs for flame
effect & log-set will be ON. To adjust the flame intensity, hold down
the button - the flame optics will go higher or lower. Once you have
found the desired setting, release the button. Pressing the button
again will stop the light function.
750W:
Press this button for low heat level. The unit will beep, the
pilot light and indicator light will be on. The fireplace heater will
give low heat level. Pressing once again will stop the low heat level
function.
1500W:
Press this button for high heat level. The unit will beep, the
pilot light and indicator light will be on. The fireplace heater will give
high heat level. Pressing once again will stop the high heat level
function.
HEAT TEMPERATURE CONTROL KNOB:
To adjust the temperature
to your individual requirements, turn the temperature control dial to
the right (clockwise) to increase the desired temperature and to the
left (counter clockwise) to lower the temperature.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and it will beep once, this means
you have power and your remote is ready to operate your electric
fireplace.
O/I:
Press this button for main power function. The unit will beep
and the indicator light will be on. Pressing again will stop the main
power function. Once the heater is switched off, the indicator light
will flash and the unit will keep working with air flow for 5 more
seconds.