Helpline No. UK 0151 649 1500 / IRE 189 094 6244
11
3. Getting started
Before starting the machine
Chain break mechanical test
Your chain saw is equipped with a Chain brake
that reduces possibility of injury due to kickback.
The brake is activated if pressure is applied
against brake lever when, as in the event of
kickback, operator’s hand strikes the lever. When
the brake is actuated, chain movement stops
abruptly.
Warning:
The purpose of the chain brake is
to reduce the possibility of injury due to kickback;
however, it cannot provide the intended
measure of protection if the saw is operated
carelessly. Always test the chain brake before
using your saw and periodically while on the job.
To test chain brake
1. The Chain brake is DISENGAGED (chain can
move) when BRAKE LEVER IS PULLED BACK
AND LOCKED (Fig. 13).
2. The chain brake is ENGAGED (the chain is
locked) when the brake lever is pulled
forward and the mechanism (Fig. 14/Item A)
can be seen. It should not be possible to
move the chain (Fig. 14).
Note:
The brake lever should snap into both
positions. If strong resistance is felt, or lever does
not move into either position, do not use your
saw. Take it immediately to a professional
Service Centre for repair.
14
12
13
