Original instructiOns
1600 Watt
Electric rotary Mower
HElPlinE nO 0844 8010979
d2
StARtING
Connect the plug to the mains and switch
ON.
the switchbox is provided with a lock-off
button to prevent accidental starting.
With one hand press and hold the safety
button (D1),with the other hand squeeze
the switch lever (D2) towards the handle,
and release the safety lock off button. The
machine is now started , wait until the motor
is at full speed before cutting the grass. The
switch lever should be continuously engaged
to keep the lawn mower switched on.
to SWItch the lAWN MoWeR off
Simply release the switch lever and the lawn
mower will switch off.
2. AdJuStING the cuttING heIGht (See fig e)
WARNING!
Stop the machine and
release the switch lever. Unplug the
mains cable from the power supply and wait
for the blade to come to a complete stop.
Caution the blade will continue to rotate
after the machine is switched off, a rotating
blade can cause injury.
cAutIoN:
Do not touch rotating blades.
The lawnmower can be set to 6 cutting
heights between 20 mm and 70 mm.
1. Move the cutting height adjustment
lever outwards then adjust to the preferred
position.
2. This system will adjust all four wheels at the
same time, up or down.
3. MoWING (See fig f)
f
2
For cutting convenience, it may be best to
start mowing at a point close to the power
supply and to work your way away from
the supply. Mow the lawn at a right angle
from the power supply and place the power
cable to the side of the lawn which has
already been cut.
Note:
The motor is protected by a safety
cut out which is activated when the
blade becomes jammed or if the motor
is overloaded. When this occurs stop the
machine, remove the plug from the power
supply. The safety cut out will only reset when
the switch lever (2) is released. Clear any
obstruction and wait for a few minutes for the
safety cut out to reset before continuing to
use the mower. At this time do not operate
the switch lever (2) as this will prolong the
reset time of the safety cut out. If the mower
cuts out again increase the height of cut to
reduce the load on the motor.
WARNING!
When mowing do not allow
the motor to labour particularly in
e
