10
7. Recalibrating the Drone's Gyroscope
All the spare parts below can bought from your local distributor.
Body cover
Main blades
Protecting frames
Landing skids
Motor holder
Lampshades
Motor A/B
Light boards
Receiver board
Battery
USB
charging cable
Controller
The bottom
SPARE
PARTS
Camera K300C/Wifi
If flight cannot be corrected through fine tune trimming, try the following directions to recalibrate the drone's inner gyroscope:
(1) Place the drone on a flat, level surface.
(2) After matching the drone and remote, switch the speed to high speed, and then push the joysticks to the bottom right corner as
shown. When you hear two beeps and a red light flashes, it means the recalibration has been successful.
The drone must be on a flat surface to be recalibrated.
Joysticks must be on the bottom right corner at the same
time
