Locate the center set of pinch weld
holes and install the support bracket
using 6mm hex head bolts, washers on
both sides and secure with a 6mm ny-
lock nut using a 10mm hex wrench and
a 10mm socket. (FIG 7)
Lastly install the 10mm hex bolt from
front to back with a washer on both
sides and secure with a 10mm nylock
nut using a 16mm hex wrench and a
17mm socket. (FIG 8)
Repeat steps on the opposite side.
Installation is complete.
The Trusted Source
®
5
Locate the 3 vertical threaded holes
behind the pinch weld. Align the holes
in the brackets with these holes. (FIG 5)
Install the 8mm hex bolts, lock washers,
and washers using a 13mm socket.
Repeat on the two remaining holes.
(FIG 6) Then, holding the rocker up
on center with the pin weld holes fully
tighten the 6mm hardware. Once snug
you may now tighten the 8mm bolts
underneath.
Side Armor with Steps Installation:
Torque for 6mm Hex Head Bolt (hardware C & E) = 8 ft-Lbs
Torque for 8mm Hex Head Bolt (hardware B) = 16 ft-Lbs
Torque for 10mm Hex Head Bolt (hardware A & D) = 37 ft-Lbs
FIG 5
FIG 6
FIG 7
FIG 8
QRC_SIDE_ARMOR_JL4dr_12004_3214.qxp_Layout 1 1/16/19 4:40 PM Page 5
