3
The Trusted Source
®
After loosely installing, carefully check
to make sure the light bar fits snugly
between the two brackets. You may
need to make some minor adjustments.
Fully tighten the T40 fasteners before
installing the light bar.
While supporting the light bar parallel
to the hood install the 6mm socket
headed screw, lock washer and flat
washer through the hole in the bracket
and thread it into the light bar. Install
another 6mm screw, lock washer, and
flat washer into the slot on the bracket.
Continue to support the bar and repeat
on the opposite side. Snug the cap
screws with a 5mm hex key but do not
fully tighten at this time.
Route wires as needed. Please refer to
the light bar and harness instructions
provided with those components. The
slots on both brackets can be used to
secure the wires using the supplied zip
ties.
Adjust the light bar to the desired angle
and then fully tighten all 4 socket
headed screws with a 5 mm hex key.
J3 Lightbar installation is complete.
Lightbar Installation:
J3_HMT_TJ_97109_2002_A4.qxp_A4 4/13/18 3:26 PM Page 3
04132018152645
