Tailgate Bike Pad Installation:
After unpacking the tailgate Bike Pad lay it flat on the ground.
With the tailgate close
d
,
position the bike pad on top of the tailgate. Adjust the pad
so that the panel rests flat
on the tailgate
while the pad’s lower straps dangl
ing
below. Fig 2.
FIG 1
FIG 2
Important Safety information
Your QuadraTop® Tailgate Bike Pad is in-
tended to provide tailgate protection from
carrying bikes on your off-road capable
vehicle. Before installation,
please take a moment to review the fol-
lowing safety information and installation
instructions. Important safety information
is generally preceded by one of three
signal words indicating the relative risk of
injury. The signal words mean:
a hazardous situation which, if not avoided, could result in death or serious in-
jury. You CAN be KILLED or SERIOUSLY HURT if you don’t follow instructions.
WARNING
CAUTION
NOTICE
a hazardous situation which, if not avoided, could result in minor or moderate
injury. You CAN be moderately HURT and also may suffer property damage if
you don’t follow instructions.
Careful attention is required to this instruction or operation but does general-
ly not relate to personal injury. Damage to your Quadratec® product or other
property may result if you don’t follow instructions.
Threading Straps through Buckles:
Throughout the installation, you will need to thread webbing
straps through buckles several times. Please review the pic-
ture for correct strap routing through the buckles. As a rule
of thumb, run the strap below and through the sewn side
of the buckle first and then back down through the end of
the buckle. Tighten the strap by simply pulling the exposed
webbing after threading the strap through the buckle.
Pre-Installation of Tailgate Bike Pad
When unpacking, carefully check to make sure all parts are included. If any part is missing
or broken, please call Quadratec customer service at 800-745-6037.
