The Trusted Source
®
5
Bike Rack Assembly:
Position the receiver tube (B) into the rack
assembly as shown with the supporting
rib facing as shown. Secure the receiver
tube to the main rack with QTY 2
½” button head bolts (L), Qty 4 ½”washers
(M), and QTY 2 ½” nylock nuts (N).
Tighten the bolts with the provided 5/16
hex key (V) & ¾” wrench (W). (FIG4)
Locate the tire cradles (F) and position
them on the crossbars with tire holders so
that the higher end of the cradle is facing
the middle of the rack as shown. Install
Qty 2 M8 bolts (O) down through each
holder and through the crossbar. Install
QTY 2 M8 washers (P) and Qty 2
M8 nylocks (Q) and tighten them with
the 13mm combo wrench (W). (FIG5)
Install the tire holder (E) onto the
crossbar arm facing the back of the
rack as shown. (FIG6)
Using a M5 Hex Wrench, install (2) M6
cap screws (T) into either the end of the
crossbar arm as shown. Repeat on 2nd
crossbar arm. (FIG7)
Assembly now complete.
See next page for instalation.
FIG4
FIG5
FIG6
FIG7
Note: There are 3 mounting
holes to accomodate
different length bikes.
Q_PLATFORM_RACK_INST_A4.qxp_A4 6/10/19 3:52 PM Page 5