Step One: Remove Doors
Put on safety glasses. Start by removing
your Jeep doors and locating the upper
door hinge on the driver’s side.
Step T wo: Install Mir ror Arm
Install a metal washer and then a nylon
washer onto the threaded end of the
.
1
e
r
u
g
i
F
n
i
n
w
o
h
s
s
a
m
r
a
r
o
r
r
i
m
As shown in Figure 2, install the mirror
arm into the door hinge and then from
the bottom, install another nylon and
steel washer, followed by a nyloc nut.
Make sure the nylon washers are sand-
wiched between the steel washers and
in contact with the door hinge so as not
to damage the paint on the vehicle.
As shown in Figure 3, tighten the
Nyloc nut using a 14mm wrench or
socket while holding the mirror arm
in place. Tighten until the arm is snug
in the door hinge but not so tight that
it cannot be adjusted.
READ ALL SAFETY MESSAGES AND ALWAYS WEAR
SAFETY GLASSES WHEN WORKING WITH TOOLS.
Figure 1
Figure 3
Figure 2
Q_ADV_MIR_13111_040X.qxp_A4 4/14/16 4:07 PM Page 2
04142016160822
