The Trusted Source
®
10
Final Adjustment:
You may now tighten the M10 allen head hardware through the tow hooks to 55ft
lbs. Torque the over rider bar bracket to winch plate Hex Head M10 hardware and
bracket to outside of the frame rail to 38ft lbs.
Now torque the remaining over rider bar M10 mounting hardware to 38ft lbs.
Installation is now complete.
Your Bumper has been designed and
manufactured to provide years of use.
However, like any product, general
maintenance is required to keep it
looking new.
Since the bumper is located on the front
of the vehicle, it is subject to potential
rock chips and other debris potentially
causing portions of the paint to chip off.
We recommend using a textured or gloss
black spray paint sprayed on a piece of
cardboard and Q-Tip to gently fill in
these chips. This will prevent any
corrosion from forming. On all bumpers
there is a chance of some surface corro-
sion showing over time due to metal
particles being embedded in the paint.
This surface corrosion is easily removed
by a non-abrasive cleaner/polish and a
soft bristle brush (not a metal brush!).
For bumpers with a textured finish,
wash only with soapy water and avoid
other waxes and polishes.
Bumper Care:
FIG26
Final Adjustments:
Q_JK_ALUM_FBMPR_12057_9261_A4.qxp_A4 11/12/19 11:50 AM Page 10