The Trusted Source
®
4
QRC JL Front Bumper Installation Prep:
Put on safety glasses. Start by removing
the factory splash guard. Remove the 8
plastic push rivets on the underside of
the bumper. (FIG1)
Remove the two screws on the under-
side using a 5/16” socket. (FIG2) Re-
move the splash guard. Note: This will
not be reused with your QRC bumper.
Remove the two bolts holding on the
Original Equipment cross shield using a
16mm socket. Remove the cross shield
by lifting upward and out. Note: This
will not be reused with your QRC
bumper. (FIG3)
Locate the frame guard plastic retainers
on either side. (FIG4)
Remove the plastic retainers using
a small flat blade screwdriver. (FIG5)
FIG1
FIG2
FIG3
FIG4
FIG5
QRC_F_BUMPER_JL_12057_014X_LTR.qxp_Layout 1 10/18/18 11:20 AM Page 4
