The Trusted Source
®
3
Installation Step One:
Step One: Removing Existing Bumper
Put on safety glasses. Locate the six fac-
tory bolts holding your existing bumper
to the frame of your Jeep
®
(Fig 1).
Using the proper tool/wrench, remove
the top and bottom bolts holding the
bumper to the frame and put them in a
safe place. These bolts will be used to
re-install your tube bumper to your
Jeep
®
(Fig 2).
Figure 1
Figure 3
Figure 4
For ’87-’95 Wranglers equipped with factory front tow hooks, these will
need to removed and discarded. These tow hooks are not compatible
with Tubular Bumpers. Original equipment hardware must be replaced
with (2)
1
⁄
2
”- 13 x 1 -
1
⁄
2
” Grade 8 bumper bolts & washers for proper
installation of bumper. These bolts & washers are included in this kit.
Installation Step Two:
Figure 2
Installing Front Tubular Bumper
As seen in Figure 3, Your Front Bumper
has custom hole locations that allow it
to fit many model year vehicles. Care-
fully line up the proper holes on the
mounting tabs with the front holes of
the frame and locate on the bumper
mounting tabs the proper holes to in-
stall your bumper. The bumper should
be centered on the front of the vehicle
and as close to the frame horns as
possible (Fig 4).
QRC_F_Tube_12057_0102_LTR.qxp_Layout 1 5/16/16 4:21 PM Page 3
05162016162437
