Place the third brake light ring over the
studs on the tire carrier as shown with
the attached harness located at the
bottom of the ring. You may temporary
secure the brake light ring by finger
tightening one of the lug nuts on to
the tire carrier studs.
Open the tailgate of the vehicle and
locate the 4 T20 screws on the backside
of the factory 3rd brake light housing.
Remove the 4 screws with a T20 torx
driver.
Put on safety glasses. Remove the lug
nuts that secure the spare tire using lug
wrench and correct socket (factory lug
nuts use ¾” socket). Carefully remove
the spare tire. Pass the connector and
harness from the third brake light ring
behind the spare tire carrier and out
the top.
3
The Trusted Source
®
Installation Instructions:
RING_OF_FIRE_A4.qxp_A4 1/18/18 12:19 PM Page 3
01182018122033
