Quadralite VideoLED 600 User Manual
NOTE!
POWER
(
1
) power switch may be set in two positions:
O
- lamp switched off,
I
- mains supply,
You can connect the power cord only if the switch is set to
O
position. Failure to
comply to this recommendation may damage the device.
2. After the power cord is connected to the device, turn the lamp's switch (
1
) to
I
position.
Light Output Adjustment
Light output may be adjusted with a knob (
3
). To reduce the brightness, turn the knob in the counter clockwise
direction. To increase the power, turn the knob in the opposite direction.
Fuse Replacement
The device is equipped with a 10A (
2
) fuse; its socket is located above the power socket. If the lamp stops
working, check if the fuse has not been blown. A blown fuse should be replaced with a fuse of the same type
and parameters (10A). It is forbidden to use fuses featuring different parameters. Fuse should be replaced only
if the lamp is disconnected from power supply, and the device's switch (
1
)
is set to the "O" position. If the device
is still not functioning after the switch replacement, contact Quadralite brand's authorized service center.
Warranty and Maintenance
1. Turn the device off immediately if it works improperly or when you find that the lamp's casing or the
power cord is damaged.
2. Protect the lamp against shocks, impacts and dustiness, and regularly keep the casing clean.
3. The lamp may heat up during operation. This is normal especially when you use the maximum light
output.
4. Repair, maintenance and cleaning of the lamp's internal components may be carried only by the
authorized service center. Repairing the lamp outside the authorized service center shall void the
warranty.
5. Do not use the lamp, if you suspect that it is damaged, dusted or exposed to excessive moisture.
In such a case, immediately contact the authorized Quadralite service center to evaluate the device's
suitability for further operation.
6. Before attempting to transport the lamp, you must always disconnect it from the power source
and wait until it completely cools down.
7. Clean the lamp only if it is turned off and disconnected from the power source. Clean the device with a
dry brush, and in the case of stubborn marks with a slightly moistened, soft cloth. Do not immerse the
device in water and do not use detergents to clean its surface. Only surface cleaning is possible!
Technical Data
Name:
Quadralite VideoLED 600
Type:
Continuous Light Studio Lamp
Light Source:
LED Diode,
Output:
60W
Brightness Adjustment:
smooth
Color Temperature:
5400K (±100K)
Accessories Mount:
Bowens
Cooling:
passive (radiator) and active (cooling fan)
Fuse:
10A
Power Supply:
200~240V 50Hz
Dimensions:
136 x 127 x 300 mm
Weight:
2.2 kg
Made in China
www.quadralite.pl
Page 4
