Quadra-Fire VOYAGEUR GRAND VOYA-GRAND-MBK, Owner'S Manual

Page: 26 / 36

26 January 20, 2020 7075-208N
VOYAGEUR GRAND Insert ACC
E. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been
partially disassembled and the right side lowered.
Follow steps 1 through 4 on page 25 for removal
of the tube channel assembly. It is not necessary to
completely remove the tube channel assembly.
3. Once the baffle protection cover has been removed,
pull the baffle boards and ceramic blanket forward
about 1 inch (25mm) and then overlap the baffles about
1-2 inches (25-51mm) ( Figure 26.1) .
4. Slide the tube channel assembly to the left as far as
it will go and lower the right side. Remove the baffle
boards and ceramic blanket together ( Figure 26.2) .
5. Re-install in reverse order. Be sure the baffle boards
and ceramic blanket are in their proper positions ( See
Figure 15.1 on page 15).
Figure 26.1
Figure 26.2
Figure 26.3
Baffle Boards Overlapping
Ceramic Blanket
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
F. Wiring Diagram
White Black
White
Black
Black White
Blower
Snap Disc
Rheostat
Switch
Power Cord
Figure 26.4 - Door Handle for Arched Door
G. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in
Figure 26.4.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod (
Figure 26.4).
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
CAUTION!
Do not over tighten lock nut. The door
handle needs to move smoothly.
f i r e - p a r t s . c o m