32
Quadra-Fire • Sapphire • 7055-116 Rev. D • 6/11
Handle glass assembly with care.
CAUTION
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.
J. Glass Door Assembly
Figure 8.16
Turn the appliance OFF and let it cool down
before replacing the inner glass door assembly.
Remove the glass door assembly by opening latches at the
bottom front of the appliance, on both the left and right sides.
Lift towards you and away from the appliance.
Replace with a new glass door assembly.
Lift toward you and
away from appliance
Pull Latch Forward
NOTE:
The glass, gasketing, and frame must be replaced
as a complete unit as supplied by the manufacturer.
Do NOT use substitute material.
K. Optional Blower Installation
Tools Required:
#2 Phillips head bit; hand drill; 11/16 in.
wrench; and a 5/16 in. wrench.
Attach with 4 Screws
Install Snap Disc
through the Bracket
Secure with
5/16 in. nut
From The Kit You Will Need:
Blower motor; wire harness;
rheostat; rheostat nut; knob; screws; and 1 zip-tie.
From The Stove Component Bag You Will Need:
Snap
disc bracket and 5/16 in. nut.
Figure 8.17
Turn off gas supply (if gas is connected), and
remove the rear shield. Remove the blower from pack-
aging. Place the blower under the appliance. Attach the
blower from the front with four screws to the blower bracket.
Figure 8.18
Install the snap disc in the bracket. Attach the
bracket to the fi rebox with a 5/16 in. wrench.
Figure 8.19
Connect the electrical connectors to the snap
disc.
