May 5, 2015
7036-188E
21
MT VERNON AE INSERT
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTICE:
Due to the abrasive nature of a pellet appliance fi re, the logs
are not covered under warranty. Any placement variation
other than shown here can cause excessive heat and shall
void the appliance warranty.
Figure 21.1
Log fits over screws
Left Log
Log has indentations on the
bottom to fit over the screw
heads.
Log rests in front of screws
Right Log
Figure 21.3
Figure 21.4
G. Optional Log Set Placement Instructions
2 PIECE LOG SET INSTALLATION
1. Place the left log as shown. There are 2 indentations in
the bottom of the log to fi t over the screw heads in the
fi rebox.
Figures 21.1 and 21.2.
2. Place the right log in front of the 2 screw heads in the
fi rebox.
Figures 21.3 & 21.4.
Figure 21.2
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
CAUTION
H. Wall Control Thermostat Installation
1.
When mounting the wall control thermostat on the wall,
be sure to follow your wall control’s installation instruc-
tions carefully.
NOTE: The wall control thermostat should be mount-
ed on an inside wall and not in direct line with the
appliance convection air.
NOTE: If the wall control thermostat is located too
close to the appliance, you may need to set the
temperature setting slightly higher to maintain the
desired temperature in your home.
2.
There is a 5 screw terminal block located at the lower
left of the appliance, behind the cast side.
The center 3 screws are for the wall control thermostat
wires and the 2 outer screws are mounting screw and
should not have wires attached to them.
The thermostat wires are color coded. The green wire
is on the top, the white in the middle and the red on the
bottom.
Figure 21.5
There are colored dots corresponding with the same
colored wire on the right side which are easily seen by
the installer. If by chance it is put in upside down the
dots will be on the left side and will not be visible.
Figure 21.5
Thermostat wires in center 3 screws
Household power inlet
12 volt power inlet (for
optional battery back-up)
Green wire
White wire
Red wire