22
7036-187M
August
13,
2018
MT. VERNON AE INSERT
b. Set Date
When the SET DATE screen is entered the month
name is highlighted. Use the UP/DOWN buttons to
select the proper month then press the button under
“Set/Next.”
The highlight will move to the day of the month display.
Using the UP/DOWN buttons, select the current date
then press “Set/Next.” The highlight will move to the
year display. Select the current year and press “Set/
Next” then the highlight will be back on the month
name display.
September
2007
September
2007
28
September
2007
28
Figure 22.1
Figure 22.2
Figure 22.3
6. User Settings
Items that are rarely changed are stored under the USER
SETTINGS.
Figure 22.4
USER SETTINGS
Temp Units F/C
Flame Height Adjust
Temp Differential
USER SETTINGS
Temp Cal
Properties
Elevations
Conv Blower Speed
Figure 22.5
Figure 22.6
Figure 22.7
TEMPERATURE CAL
71.6
O
F Cal Adj:
-13
DONE
SET
Figure 22.8
WC
SC
CB
CV
40h
6Bh
000
000
UFTI: 029
Rev: 004
TC: -28
PROPERTIES
DONE
Figure 22.9
a. Temp Appliances F/C
TEMP Appliances is used to change from Fahrenheit to
Celsius and back for the temperatures displayed.
b. Flame Height Adjust
FLAME HEIGHT ADJUST is used to adjust flame
height (fuel feed rate) for specific installation and fuel
type. The dealer will usually adjust this if necessary on
installation and can advise on specific settings for a
particular application.
c. Temp Differential
TEMPERATURE DIFFERENTIAL is used to change
the set default temperature differential. This sets how
far below the set point the wall control allows the room
temperature to fall before the appliance turns back on.
It is usually set at time of installation.
d. Temperature Calibration
TEMPERATURE CAL is used to calibrate the
temperature on the wall control. If for some reason
you feel the wall control is not accurately reading the
temperature you can calibrate it to a thermostat that
you know is accurate. Press the UP/DOWN buttons to
desired temperature.
e. Properties
PROPERTIES shows the version of software for the
control board and wall control. If you are placing a
service call with your dealer, they may ask you to go to
this screen and read them the information under “WC”
and “SC”.
