23
08/23
7038-227L
Figure 23.2
4
1
1
1
1
6
Baffle Boards
Ceramic Blanket
Baffle Protection Channel
Brick Retainers
Right Side
Rear Brick
Side Brick
Tube Channel Assembly
Tube Channel Nuts X3
Bolts X3
1
2
4
3
Rotate and
remove from
firebox
F. Tube Channel Assembly Replacement
Service Part: SRV7038-008
Removing Tube Channel Assembly
1.
Remove the right side shield by removing three (3)
Phillips screws from back of appliance; then pull back
of side out and push back on side.
2.
Remove four (4) Phillips screws from channel access
cover and remove cover.
3.
Locate three (3) channel nuts inside of chamber and
remove using a 7/16 socket wrench
(Figure 23.2)
.
4.
Inside of firebox, remove the right five (5) side bricks
and one (1) right rear brick
(Figure 23.2)
.
5.
Remove the two (2) brick retainers by sliding back and
then up
(Figure 23.2)
.
6.
Remove the baffle protection channel by rolling forward
and out of the firebox
(Figure 23.2)
.
7.
Remove three (3) bolts from inside fire box
(Figure 23.2)
.
NOTE:
Soak the bolts with penetrating oil for at least 15
minutes before trying to remove them.
Ensure manifold tube gasket is placed
between firebox and manifold tube assembly
during re-installation process.
CAUTION
Replacing Tube Channel Assembly
8.
Slide the tube channel assembly to the left. Drop the
right side down, then slide the assembly back to right.
9.
The ceramic blanket and both baffle boards can
be removed at the same time you remove the tube
channel assembly.
10.
When the tube channel assembly is free of the left side
support, rotate clockwise and pull assembly, blanket
and baffles out through the front opening.
11. Re-install in reverse order.
Figure 23.1
E. Door Handle Assembly
Service Parts: SRV7033-071
1. Slide door handle through door.
2.
Install additional washer(s) as shown in
Figure 23.1
3. Install key in groove.
4. Align groove in latch cam with key; slide latch cam
over shaft
5.
Install locknut but do not over tighten, the handle needs
to rotate smoothly.
6.
Install fiber handle (
Figure 23.1).
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
Do not over tighten lock nut. The door handle needs to
move smoothly.
CAUTION!
