Quadra-Fire 3100 Series, Installation, Operation And Maintenance Instructions

Page: 18 / 32

Page 18
1. Remove ash removal system top and
bottom cover plates by loosening nuts
under stove.
2. Discard both plates.
3. Insert ash removal system grate into
opening in firebox floor.
4. Continue with proper installation
according to model you have purchased:
pedestal or leg.
ASH REMOVAL SYSTEM INSTALLATION
1. Place protective pad or stove pallet on floor.
2. Lay body of stove on its back on protective
pad or pallet.
3. Line up holes in ash removal system with
holes in adapter on bottom of stove.
4. Screw ash removal system securely in place.
5. Slide pedestal over ash removal system, and
line up holes in sides of pedestal with holes
in adapter on bottom of stove.
6. Screw pedestal into place, and tighten
securely.
7. Carefully stand stove up and place in desired
location.
8. Slip wooden decorative strips onto pedestal
edges.
9. Open door of stove and check to insure
firebricks and kaowool blanket are in
their proper locations (see pages 25-26).
PEDESTAL MODEL
LEG MODEL
1. Place protective pad or stove pallet on floor.
2. Lay body of stove on its back on protective
pad or pallet.
3. Line up holes in ash removal system with
holes in adapter on bottom of stove.
4. Screw ash removal system in place.
5. Bolt cover pieces onto mounting brackets,
using outer two mounting holes.
6. Slip washers onto bolts, then bolt legs onto
mounting brackets.
7. Screw leg assembly onto adapter on bottom
of stove using eig
ht ¼”
-20 screws.
8. Carefully stand stove up and place in
desired location.
9. Use leveling bolts on legs to stabilize and
level stove.
10. Open door of stove and check to insure
firebricks and kaowool blanket are in
their proper locations (see pages 25-26).