Enabling and Assigning Ratchets For Individual Steps
1.
Set the
mode toggle
to Tune mode
.
2.
Double tap the
step gate enable button
for any step where ratcheting is desired.
•
The
scale
selection button
will illuminate for a long pulse when ratchets have
been enabled for the desired step.
•
The
scale
selection button
will illuminate for a short pulse when ratchets have
been disabled for the desired step.
3.
Press and hold the
reset button
to see how many ratchets are assigned to each
step.
•
This process will show the amount of ratchets assigned to the step that is
currently selected.
•
To see the amount of ratchets assigned to other steps, press and hold the
reset
button
and then press the
step gate enable button
for the desired step.
•
On first bootup, two ratchets are assigned to the first four steps and four
ratchets are assigned to the last four steps.
4.
After the desired step has been selected and with the
reset button
held down, move
the
length
knob to change the amount of ratchets assigned to the selected step.
5.
Set the
mode toggle
to Ratchet mode. The Octone will now ratchet for the
configured number of times on each step.
Note:
If the amount of ratchets has been assigned, but ratchets have been disabled,
each step will play and hold for the amount of time set by the number of ratchets, but
will only output the initial gate from
gate out.
Note:
The Octone will save all settings in between power cycles.
Holding Notes
Double tapping the
step gate enable button
of any step will make the Octone hold on
that step for as long as the button is held down. Gates will still output from
gate out
at
the rate of the internal or external clock. The desired step's gate must be enabled for
this to function
This process also works in Ratchet mode, but ratchets must be enabled for the desired
step.
10