Setting Up:
1.
Unpack the HZ-800 unit.
2.
Unscrew the top cap of the tank and remove to fill with haze fluid.
3.
Replace the bottle and screw the cap securely, making sure that the pipe is fed down
to the bottom of the bottle to ensure a consistent flow of fluid.
4.
Connect the wired remote controller to the socket on the rear panel.
5.
If DMX is to be used for control, connect the DMX signal from the controller to the
DMX IN XLR connector. Any further DMX controlled units may be connected via the
DMX OUT XLR connector.
6.
Connect the IEC mains plug and power the unit on.
7.
The unit will begin the warming up process and the display panel on the wired remote
will display
“
Warm up
”
which normally takes around 3-5 minutes.
8.
Once the unit is warm enough for use the display panel will change to
“
Ready
”
.
Operation:
Use the control buttons on the panel of the wired controller to operate the unit
’
s modes and
functions quickly and efficiently as below:
Button
Response
Function
Scrolls between DMX, Pump, Wind, Interval and
Duration modes
Up
Increase function or setting
Down
Decrease function or setting
Timer
Enter timer mode
Start/Stop
Turn pump on/off
Manual
Manually adjusts the fan speed
The LCD panel on the wired controller will display the following outputs:
Function
Display
Warm up state
Warm up or Ready
DMX address code
1-512
Pump settings
Pump
Fan settings
Wind
Time setting
Interval
Continuous smoke time setting
Duration
The small RF remote control supplied can also be used when wireless control of the unit is
needed. Its possible to increase and decrease the values of the pump (button A) and wind
(button B) settings using the remote control. As the receiver for the RF remote is fitted inside
the wired controller this must be connected and switched on for it to function correctly.
