QTech SMS Lite
– Quick Start Guide V1.5
5
www.qtech.co.nz
Ph: +64 3 366 3713
Page 5 of 21
Getting Started
In order to operate the SMS Lite, the device must have a mobile number registered as
‘Phone 1’ referred to as Ph1. You must register this number before you can configure
any of the inputs or outputs.
The device can have up to 4 numbers registered; it is recommended that Ph1 is the
main contact as any alarm escalations programmed will step in numerical order Ph1,
Ph2, Ph3, and Ph4. If there is no response the next number in the list is sent a
notification after 10 minutes
or
if a busy message is received from the previous phone
the next person is also notified.
To Register Phone 1 (Ph1)
– Master User
1. Locate the PIN (Personal Identification Number) printed inside your SMS Lite case.
2. Compose text message to the SMS Lite mobile number in the following format:
#[PIN][space]Ph1:number=0123456789[dot]
.
e.g.
#12345 Ph1:number=027987654.
3. A confirmation text will be sent to you acknowledging a configuration change.
Use the above format to programme up to 4 individual phone numbers.
Note
– Each configuration command must be finished with a full stop
.
i.e. #[PIN][space]Ph2:number=0123456789[dot]
Note
–
The PIN is used each time a configuration change is made.
If you make a mistake in any configuration message, you can override
the current setting by sending a new configuration message. You can also clear a
configured input, output or phone number by sending configuration message with a
blank value: #[PIN][space]Ph2:number=.
e.g.
#12345 Ph2:number=.
SMS Lite
SMS Lite
You have changed the
configuration of the SMS
Lite. Send “INPUTS”,
“
OUTPUTS
”, or
“PHONES” to view the
configuration.
#12345 ph1:number=027987654
.
